Team Benefits

Go to Safety and Environmental Benefits

Go To Monetary Benefits

IMG_2
A footprint of 25″ x 60″ and standing less than 34″ tall to bed.
A 2,000 pound mold splitting capacity.
A 2,000 pound mold tipping capacity.
Machine operates on 120V and less than 15 amps.
Platens use electromagnets with over 2,000 pounds hold per platen.
Machine weighs less than 1,000 pounds.
Movable platen time mold opening or mold closing is less than 25 seconds allowing people to get to work quickly.
Mold tipper movement to 90 degrees in under 55 seconds with a limit load to allow work to begin sooner.
Tipper platen can be used as a work area after tipping to 90 degrees.
All electrical boxes are Nema 4X rated with IP66 rating.
Machine can be easily moved with a pallet jack to locate in building minimizing the physical equipment that must be moved in order to put the Wee-Split in place.
Both platens movement limited by proximity switches which helps prevent distracted operators from damaging the equipment.
Pilot lights on machine and each set of magnets to show if power is on to demonstrate that it is safe to continue operation.
Minimum spacing between platens of less than 5″ so most small molds can be closed between platens.
Machine can be used directly on the clean room floor saving mold transport activity.
Bed can be used as a work table requiring less transporting of mold halves .
Machine has an IR remote control for all functions which allows 
the operator to stand 3-5 feet away from moving parts.remote1a